Bump firmware version to 1.0.0

src/barcodescanner/config.py

@@ -43,9 +43,9 @@ TRIGGER_PIN = 2 # Pin that connects to the scan module's trigger line, pulls the
 UP_BUTTON_PIN = 10 # Pin to read for navigation up button
 DOWN_BUTTON_PIN = 11 # Pin to read for navigation down button
 HAS_WS2812 = True # Has an WS2812/Neopixel, will use instead of normal LED
-WS2812_PIN = 13 # GPIO pin for WS2812
+WS2812_PIN = 3 # GPIO pin for WS2812
 LED_PIN = 3 # "LED" for testing, 3 for prod
-FIRMWARE_VERSION = "0.0.1"
+FIRMWARE_VERSION = "1.0.0"
 
 #
 # Scanner configuration
@@ -70,7 +70,7 @@ USBHID_ENABLED = True # Disable USB, use serial output only (good for debugging)
 #
 # Display configuration
 #
-ENABLE_DISPLAY = False # Set to False to ignore display commands
+ENABLE_DISPLAY = True # Set to False to ignore display commands
 DISPLAY_WIDTH = 128
 DISPLAY_HEIGHT = 64
 CHAR_WIDTH = 8